Skip to content

Shop Floor Insight

Missing operations on Production Dispatch page

Viewing 3 posts – 1 through 3 (of 3 total)
  • Author
    Posts
  • #8932
    Nathanial M.

    Hi

    I am finding that some of my production order operations are missing from the dispatch page.

    In some cases it is the last 2 processes, in others the whole set are missing.

    However, when I filter the to the prod order number in the shop floor interface, all routing lines appear.

    Why is this happening?

    Things checked so far.

    There is no Prod Order Routing Line Filters in either shop floor setup or shop floor client configurations. All work/machine centres exist as shop floor work centres.

    No pattern to whether this is work centre/machine centres that are missing

    There isn’t even commonality between which work/machine centres are missing.  Some which appear OK on some prod orders are missing on all.

    These are new production orders which no postings against them.

    I have extracted the prod order routing lines and routing lines as config packs and can’t spot any difference….

    #10775
    Michaylla B.
    Insight Works

    Hello,

    It would appear your issue is simple – you have too many routing lines displayed and you are hitting the maximum. Searching for the production order number in the dispatch list will show you all routing lines for that production order number, but you may not see them all if nothing is set there in the filter and you have a larger number of routing lines in BC.

    What you see in the Production dispatch list will depend on a few things.

    -Which released production order routing lines you have on the production order
    -The filter you could have in the SF client configuration card. See the “Prod routing custom filter” field near the top. (you need to look at the SF client config card you are using)
    -The filter you could have on the SF setup page. See the “Prod routing custom filter” field near the bottom, in the “Global Dispatch” sub-section. Both filters are applied – the one on the SF setup page applies to everyone.
    -The other relative date filters you have on the SF setup page, in the Global Dispatch section. You can turn this off by setting the “Filter Start Date” and “Filter End date” settings to “Do not filter”
    -The total number of routing lines you have. (this is your issue) There is a maximum number of routing lines displayed. See the “Dispatch Row Limit” field in the Global Dispatch, on the SF setup page. We don’t recommend a value that is higher than 200 as this can slow down the client. Instead, you should have some filters configured and multiple SF client configuration cards so that you can see the relevant things at each station on the floor.
    -Another possibility is the “Dispatch Employee filtering” setting, in the Global Dispatch section. Set this to “Do not Filter”.

    Here are a few links for your reference:

    Release notes of Shop Floor Insight: https://kb.dmsiworks.com/knowledge-base/release-notes-shop-floor-insight/
    Article on dispatch list filtering:   https://kb.dmsiworks.com/knowledge-base/production-dispatch-lists-that-boost-efficiency/

    The SF client configuration cards: https://kb.dmsiworks.com/knowledge-base/configure-client-configuration-in-shop-floor-insight

    Recommendations on the Shop Floor Client Configuration cards: https://kb.dmsiworks.com/knowledge-base/shop-floor-client-configuration-cards-recommendations/

    If you have any further questions, I would recommend you email our support portal.

    Regards,
    LP

    #10785
    Nathanial M.

    Hi

    I can confirm that the Dispatch Row Limit was the issue

    All resolved

    Thank you

Viewing 3 posts – 1 through 3 (of 3 total)
  • Sign in below to reply.