Skip to content

Advanced Inventory Count

Lot numbers not matching in Advanced Inventory Count

Viewing 8 posts – 1 through 8 (of 8 total)
  • Author
    Posts
  • #8516
    Blaine P.

    Hi, I create a count sheet, which is pre-populated with the lot numbers.  Then, when we do our inventory, when scanning the very same lot numbers, they are not matched up and it creates new lines with the same lot numbers.  I’ve verified that the lot numbers are identical in every respect.  Is there a setting that would be causing this to happen, or any advice anyone has?

    #9981
    Jake D.

    I am having a similar issue; However, my Lot Nos. are simply not populating on all of my lines when I generate the Master sheet leaving me to view check the item availability overview to verify for my team. I have manual entry enabled, so it is not a showstopper, but still wondering if there is a solution to the problem.

    #9982
    Olina T.
    Insight Works

    The settings on your Device Configuration > Inventory count tab, Inventory Count Item Behaviour is set to ‘Add New Line When missing.’

    If it is set to ‘Always add the new line,’ it will do just that.

    #9983
    Olina T.
    Insight Works

    If the Item tracking is not getting set, you need to make sure they exist on entries in BC.

    If your item is, for example, set only to track outbound, the item will not have tracking in BC to be counted.

    To know why your time tracking is not getting set, we would need to investigate your data. If you wish to investigate further, contact us with further details at Su*****@*******ks.com

    #9988
    Blaine P.

    Thank you, Olina.  I checked and our Inventory Scan Item Behavior was (and is) set to “Add New Line When Missing”.  I believe we are talking about the same setting, as you mentioned a setting “Inventory COUNT Item Behaviour” – mine shows “Inventory SCAN Item Behavior”.  Am I looking at the wrong setting, or is it the same thing?

    Thanks again for any insight, you helped me to at least find the setting, but I think it is already the way we want it, even though it is still adding lines for existing same parts for some reason….  (bummed)….

    #10015
    Stephanie C.

    We are having the exact same issue here.  The count lines are populated with lot numbers, but when employees go to scan it creates a new line for every scan and does not match them up.  Our settings are the same as yours- under Inventory count settings 0 inventory scan item behavior – Add new line when missing.   I am hoping to get this resolved before we do year end counts.

     

    #10016
    Olina T.
    Insight Works

    If the scan is still creating a line, the Bin, item or lot are already on the sheet, and the settings on your Device Configuration > Inventory count tab, Inventory Scan Item Behaviour is set to ‘Add New Line When missing’ is set, then there must be something else. What would that be? We would need to investigate the data to figure it out.  To assist you with that, you would need to send an email to our support: su*****@*******ks.com

    #10017
    Olina T.
    Insight Works

    If the scan is still creating a line, the Bin, item or lot are already on the sheet, and the settings on your Device Configuration > Inventory count tab, Inventory Scan Item Behaviour is set to ‘Add New Line When missing’ is set, then there must be something else. What would that be? We would need to investigate the data to figure it out.  To assist you with that, you would need to send an email to our support: su*****@*******ks.com

Viewing 8 posts – 1 through 8 (of 8 total)
  • Sign in below to reply.