Home Forums WMS Express Warehouse Insight Software Installation

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
  • Calvin QuigleyCalvin Quigley
      Post count: 1

      The web service has ‘=ReplaceWithAPercentEncodedCompanyName’ on step 2.  Scanning this on the handheld does not work.  Any ideas?

      Brandon EstradaBrandon Estrada
        Post count: 10

        Hi Calvin,

        The ‘=ReplaceWithAPercentEncodedCompanyName’ is auto generated in the web service and is not meant to be replaced.

        Below are the basic steps to configure WMS Express:

        1. Install the Extension and turn on the HttpClientRequests toggle in Extension Management for IWorks Common and WMS Express.
        2. Run the Assisted setup for WMS Express
        3. Generate a WMS Express Installation Report, disable Insight Works Users if not in use, and select a Device Configuration Code. Please note: the Web service URL should be auto generated and not changed.
        4. Scan the step 1 barcode to download the application
        5. Scan the step 2 configuration barcode to configure the scanner (default config password is ‘1234’)
        6. Login using the Business Central credentials containing the IWORKS COMMON and WHX – ALL permission sets.

        You can also follow the steps for configuring Warehouse Insight from our Knowledge Base here: http://kb.dmsiworks.com/knowledge-base/configuring-the-software/

        If the barcode is not scanning into WMS Express there may be some additional configuration needed for the handheld settings depending on type of handheld.

        For Datalogic and Zebra handhelds: http://kb.dmsiworks.com/knowledge-base/configure-scanner-settings-for-memor-10-20-and-zebra/

        For Honeywell devices: http://kb.dmsiworks.com/knowledge-base/device-installation/


      Viewing 2 posts - 1 through 2 (of 2 total)
      • You must be logged in to reply to this topic.