---
title: "Datalogic Falcon X3 Scanner Timeout"
app: "Warehouse Insight"
section: "Set up"
last_updated: "2020-03-24"
url: "https://insight-works.com/kb/warehouse-insight/datalogic-falcon-x3-scanner-timeout/"
---

# Datalogic Falcon X3 Scanner Timeout

If a scanner goes into power save mode or drops the wifi connection the Warehouse Insight app will need to reset and log back in each time.

On a Datalogic Falcon X3 there are 3 timeouts that need to be changed so that the device does not power down and disconnect:

1. Start >> Settings >> System >> Power >> Auto-Off

   1. If the device powers off it will need to re-connect to the WMDM app.
   2. Set both timeouts to 15 minutes (higher if the battery can handle it):

![Datalogic Falcon X3 Scanner-Timeout](/wp-content/uploads/kb-legacy/Datalogic-Falcon-X3-Scanner-Timeout-1.png)

1. Start >> Settings >> System >> Backlight >> Brightness

   1. The display can go dim while still remaining connected.
   2. Disable ‘Dim if idle’:

![Datalogic Falcon X3 Scanner-Timeout](/wp-content/uploads/kb-legacy/Datalogic-Falcon-X3-Scanner-Timeout-2.png)

Under the Auto-Off tab set both timeouts to 5 minutes:

![Datalogic Falcon X3 Scanner-Timeout](/wp-content/uploads/kb-legacy/Datalogic-Falcon-X3-Scanner-Timeout-3.png)

1. Start >> Settings >> Connection >> Laird >> Profile >> Power Save

   1. The wifi needs to stay active as long as the device is powered on (Continuous Active Mode).
   2. Change Power Save to “CAM”:

![Datalogic Falcon X3 Scanner-Timeout](/wp-content/uploads/kb-legacy/Datalogic-Falcon-X3-Scanner-Timeout-4.png)
