Skip to content

Shop Floor Insight · Set up

Prevent Over Output in Shop Floor Insight

Last updated October 7, 2026

This article describes configuration to help prevent over output in Shop Floor Insight. Use Over Output Behavior to prevent operators from recording more output than a production order line requires. This helps catch duplicate entries or incorrect quantities before they reach the output journal.

By default, Shop Floor Insight allows over output however it will still give a warning on the Shop Floor kiosk when that occurs.
To block over-output instead of just giving a warning, set Over Output Behavior to Disallow over output for the applicable client configuration.

Configure over-output prevention

  1. Open Shop Floor Setup and confirm Register Output To is Output Journal.
  2. Open the Shop Floor Client Configuration Card used by the station or employee.
  3. Find the Over Output Behavior setting, and configure it to Disallow over output.
  4. Confirm Output Entry permits output at the required operations:
    • Last Operation enables output at the final operation.
    • Any Operation enables output at intermediate operations as well.
  5. Refresh the Shop Floor Web Client browser to load configuration changes.

If you need to change Register Output To, complete the production shift and post existing output and time cards before changing the destination.

The disallow option requires Output Journal. It is unavailable when output is registered to time card lines or when Time Card Unless Last Oper. is selected. To change away from Output Journal, first return all client configurations that disallow over output to Allow over output.

Client configurations can differ between stations. An employee configuration override takes precedence over the station configuration.

Record output

  1. From the Shop Floor Insight scanning interface, clock into the appropriate production order operation.
  2. While the operation is clocked in and selected, click the Output button.
  3. Enter the quantity being completed and any other required output details.
  4. Choose Register.

If the quantity would exceed the remaining allowance, registration is blocked. On the phone/tablet Output page, the quantity is also checked when Output Quantity is changed. The same restriction applies when recording Shop Floor Insight output through the Warehouse Insight integration.  This restriction does not occur to general purpose Output Journal entries made in Business Central.

The error identifies the item and variant, expected quantity, remaining quantity, attempted quantity, and quantities already posted or waiting for approval. It also displays scrap quantities and identifies the client configuration controlling the restriction.

Correct the quantity and register again. If extra production is intentional, a supervisor can review whether the applicable client configuration should be changed to Allow over output.

How the remaining allowance is calculated

The limit applies separately to each production order line and operation. It includes both posted output and output waiting in the unposted journal. Posting the journal does not create additional allowance.

Quantities are compared in the base unit of measure against the production order line’s Quantity (Base). Scrap is shown separately and does not reduce the good-output allowance. A scrap-only registration with zero output is allowed.

For example, a production order line requires 3 bicycles, and 2 are already waiting in the output journal for the selected operation:

Attempt Result
Register 2 more Blocked: only 1 remains.
Register 1 more Allowed.
Register another 1 afterward Blocked: the operation has reached 3.

For a routing with multiple operations, output recorded against one operation does not consume the allowance for the next operation.

Output Entry controls where operators can record output. Set Initial Output Quantity To controls the default quantity shown in the output dialog. Neither replaces the over-output restriction.

This restriction applies when Shop Floor Insight registers output. It does not prevent output entered directly in the Business Central Output Journal. The QtyExceedsExpected time card validation rule is a separate check, configured as a warning by default during time card validation.

View this article as Markdown

Still need help?

Ask other Business Central users in the Insight Works community, or send the details to the support team. Include the steps you took and any error message you saw.